Carlon PVC Multi-Gard - Low Res Manuel d'utilisateur télécharger pdf

www.carlonsales.com

Multi-Gard

PVC – Assembly/Field Cuts

Assembly

Field Cuts

Distribute Multi-gard sections along

the sides of the trench with male ends

pointing towards starting vault entrance.

Remove protective cap and

install Multi-Gard terminator on

male end. Install first section

into vault opening or enclosure

making sure the print line is on

the top stating “INSTALL PRINT

LINE UP.” (See next page for

terminations.)

2. A spare spacer may be

installed to align the innerducts

if they seem loose.

2. Align innerducts on Multi-Gard section “A” with

couplings on section “B”. Solvent cement each coupling

for air tight seal and push until both ends are flush.

Apply solvent cement to both ends of Multi-Gard and

slide sleeve until it is centered on both sections.

Each consecutive 20' section can now be

placed by inserting the male end into the gas-

keted belled end

" to the gasket depth. Make

sure the print line is upright. (If not, rotate the

outer duct until it is.) Now push the sections

together with a firm push until belled end seats

against insertion line.

3. Raise both ends and align the innerducts

on the male end into the coupling body on

the female end. Lower both ends and the

innerducts will automatically return to their

original position as the joints are forced

together.

Joining Male and Female Ends

Joining Two Male Ends

1. Lay the Multi-Gard sections side by

side and mark the male end at the

base of the bell on the female end.

Make a straight cut using

a standard carpenter saw.

1. Flush cut Multi-Gard sections “A” + “B” as shown in figure 1. Slide

outerduct sleeve over Multi-Gard section “B” as shown in figure #2.

Insert end spacer into Multi-Gard plain end (chamfer side in) as

shown in figure #2. Press couplings onto innerducts of Multi-Gard

section “B” as shown in figure #3.

FIGURE 1

FIGURE 2

FIGURE 3

M CC4

–

Gross Automation (877) 268-3700 · www.carlonsales.com · [email protected]

1 2 3 4 5

Résumé du contenu

Page 1 - PVC – Assembly/Field Cuts

www.carlonsales.com6Multi-Gard®PVC – Assembly/Field CutsAssemblyField Cuts1.Distribute Multi-gard sections alongthe sides of the trench with male ends

Page 2 - PVC – Terminations

www.carlonsales.com7Multi-Gard®PVC – TerminationsStandard Terminators (Type 1) allow Multi-Gard to be terminated into a standard pre-cast termination.

Page 3 - PVC – Installation

www.carlonsales.com8Multi-Gard®PVC – InstallationAll PVC Trenching installation allowsMulti-Gard to be placed in the trenchone section at a time or ov

Page 4 - PVC – Repairs

www.carlonsales.com9Multi-Gard®PVC – RepairsRepairing Vacant Multi-GardRepairing Multi-Gard Containing Cable(s)1. Cut out the damaged sectionand inse

Page 5 - PVC – Repair Kits

www.carlonsales.com10Multi-Gard®PVC – Repair KitsRepair KitsRepairing Multi-Gard with Damaged CablesE940F PVC Coupling Couples PVC innerduct with sol